![]() If the hole in the wall is too small, check to see if the valve cartridge is the right size. Wiggle it a bit until the wall holds it firmly in place. Hold the metal end of the new cartridge with pliers and slide it into the hole where the old one came out. Once it is out, place it in a safe place, or throw it away if you don’t need it anymore. If the valve cartridge gets stuck, try to wiggle it a little before pulling it loose. Use pliers to pull out the valve from the wall by firmly gripping the metal end of the cartridge. After that, you may proceed to remove the faulty valve. ![]() Sometimes, retainer nuts hold some valves in place, and you have to use a wrench to unscrew it. New cartridges come with valve clips, but there’s nothing wrong with reusing a good old one. If the valve clip is still good, use it when installing a new cartridge. Pull out the clip and keep it in a safe place. Remove the clip that holds the shower valve in place with needlenose pliers. The trim plate should serve as a guide to the size of the hole to make. However, the handle and trim plate should be able to cover the hole properly. The information on the verified home improvement site will contain how to cut a hole into the bathroom wall properly. You can also search online on how to replace a shower valve assembly or steps to install shower valve. ![]() If you are not sure about the size of the hole to create, ask a professional plumber to do it. If the wall is made of tiles or glass, cut the hole until you get the right size. It is usually about 12 inches or 30 cm, but you need to widen the hole a little. When you remove the trim plate, there will be a visible opening in the wall. For example, shower trim plates go with the name Escutcheon trim plate. When visiting a store for your purchase, keep in mind that some parts may have a different name. In case you want to buy some, caulk is sold online and in home improvement stores. Remove the caulk if it is glued to the trim plate and the screws to the wall. You may find a layer of caulk around the edges of the trim plates. Soak the trim and the handle in vinegar to remove and make them look new once again. Keep it where you can find it when you will want to fix it back. Unscrew both sides of the trim plate and remove it from where it is secured to the wall. The reason is that you will need enough space to uninstall the old valve and installing the new one. If you can’t do it from the inside, go to the back of the bathroom and make a bigger hole. Check the opening in the wall to see if it is big enough. Pay attention while taking steps to replace a shower valve, so you don’t lose any parts in the process. Apart from the handle, use screwdrivers to remove the other parts of the showerhead. There are different models of showerheads, and each requires a different hex key. With the help of a hex, remove the handle of the shower head faucet. If there’s no other way of stopping the flow of water, cut off the main house source of water. Turn off both the hot and the cold water stops if the two are present. Water stops are usually at the right or left side of your valve cartridge. Some water stops use screws so you will need to use a screwdriver to turn them a little to the left. Find the handles that control the flow of water and turn them clockwise. The next step is to switch off the water flowing into the shower to prevent more leakage. Keep all removed parts and screws in one place to use them again when needed. Covering it also helps to prevent screws from falling off and getting lost. The first thing to do is cover the drain with a cloth while you fix the faulty valve.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |